Hello, I am practicing my arpspoofing from backtrack 5 and had a question. I did all the ip forwarding and iptable stuff with nat. I want to run sslstrip so i first start with the arpspoof -i eth0 -t now here I put my host ip address because im running backtrack in a VM in bridged mode then I follow that with my home router ip. It runs, but when I try to bring up a browser on my host computer, it never finds a site, just times out. Is this because I should be targeting a separate computer not running this on the host computer? Same thing happens when i do it to a target computer elsewhere, browser just hangs there. As soon as I control-c out of arpspoof, websites come back like normal. Am I not putting in the right ip addresses? Isnt the first one after -t supposed to be the target computers ip address followed by the router ip address?